FLEXIBLE AND DURABLE GOES FAR
  • Thermal Expansion - minimal sag increase at high power transfer
  • Stranded Core - flexible, robust and rugged. no single-point-of-failure
  • Easy Installation - install like ACSR, using conventional methods
  • Compression-type fittings - familiar hardware
  • Designs for all loading conditions - long span, light load to heavy ice load
  • Trapezoidal wire(TW) or Round wire available - optimized design options
  • Annealed (1350-O Temper) or Thermal-resistant or Hard-drawn Aluminum
HOW DOES ACFR® WORK?
Lighter ACFR can be installed higher then ACSR at the same tension which results in more room for initial sag
Until the kneepoint, the thermal expansion is almost the same for ACSR & ACFR (governed mainly by the aluminium expansion), and above the kneepoint of ACFR there is almost no further thermal expansion (fully governed by CFCC)
The kneepoint of ACFR-FA with fully Annealed aluminium is very low and lowest sag or highest capacity can be acheived
For extreme ice or wind load, a thermal alloy may be needed for increased modulus of elasticity and strength.
What is the expected lifetime of the ACFR® conductor?
Carbon fiber itself is non-corrosive and degradation of CFCC core that results in tensile strength reduction during the course of its lifecycle is minimum. The expected lifetime of ACFR® conductor exceeds that of ACSR.
Galvanic Protection barrier
CFCC uses overlapped polyester yarn wraps (0.05mm) as galvanic protection barrier. Protection performance of CFCC far exceeds the benchmark of the ACSR galvanized steel core. We have provided 20-year field exposure and numerous corrosion tests, and one of the 2000-hours salt fog tests demonstrates adequate protection of the aluminum strands even with the protection layer removed, showing that the polymer matrix resin provides a considerable degree of galvanic protection while ACSR (galvanized steel core) was severely degraded and unserviceable after exposure in the same test condition. The protection system of CFCC® is well-proven over 30 years of civil engineering applications and over 20 years of field and laboratory experience for the overhead lines application and there is not a single example of corrosion issue associated with the overlapped polyester yarn wraps.
APPLICATIONS OF ACFR®
Design Option
  • Round or trapezoidal shaped wires with 20% more aluminum or 10% smaller diameter.
  • Annealed Aluminum Highest conductivity. low tensile strength
  • Thermal-resistant Aluminum Moderate conductivity, high tensile strength
  • Either type of Aluminum can be used for ACFR depending on requirement
Type of Aluminum Hard-drawn
A1350-H19
Annealed
A1350-O
Thermal-resistant
TAL(AT3)
Conductivity [%IACS] 61.2 63.0 60.0
[%] 100 103 98
Max. operating
temperature
[C] 90 250 210
Tensile strength [MPa] 163~172 55-96 165-186
CFCC® Grade High Temperature Type Uni-strand
(Φ2.0-5.0mm)
7-strand
(Φ5.3-21.2mm)
Hear Resistance 180℃
(Continuous
operating
temperature)
200℃
(Emergency
operating
temperature)
Breaking Load Range - 11 ~ 42kN 37 ~ 586kN
Standard ACFR® Specification